WISPEED Kart H-Kart 3

It fits all hoverboards from 6.5 "to 10".

It is recommended to re-calibrate your hoverboard before using the hover-kart. In addition, this calibration must be done in a slightly backward inclined position.
You must re-calibrate the hoverboard in a horizontal position if you plan to use it without the kart.

Yes, it is necessary to ensure that the straps are all properly installed: they must not be bent, crushed or have a defect.
Before use, make sure the straps are stretched as far as possible: they should not be loose or hang down.

Your hoverboard is factory calibrated. In case it does not react properly (shaking, difficult to control ...), it is necessary to redo a calibration.

There are several reasons for your Wispeed hoverboard to beep.

1) If your hoverboard beeps at ignition:
- If the status LEDs are red, it means that your battery is discharged.
- Otherwise, your hoverboard has an electrical problem and must be brought back to your point of purchase.

2) If your hoverboard beeps during use:
- In normal use, it means either you go too fast, or your hoverboard is too leaning. This is dangerous and can lead to an accident. It is essential to slow down in order to bring the hoverboard back to a horizontal position.
- If this happens when the hoverboard is harnessed to a hoverkart, please raise the levers to reduce the tilt and speed of the hoverboard, and this, so as not to damage the hoverboard, the kart and your straps .